CDM project activity/programme of activities registration request review form (CDM-REGR-FORM) (Version 03.0)

Reference number of the proposed CDM project activity/programme of activities (PoA) submitted for registration	4420
Title of the proposed CDM project activity/PoA submitted for registration	Pure-low Temperature Waste Heat Recovery for Power Generation (12MW) in Hunan Cement Co., Ltd. of Zhaoshan Xinxing Group (ZSHN)
Please indicate, in accordance with paragraphs 37 and 40 of the CDM modalities and procedures, which validation requirement(s) may require review. A list of requirements is provided below. Please provide reasons in support of the request for review. Including any supporting documentation.
The following are requirements derived from paragraph 37 of the CDM modalities and procedures:
The participation requirements as set out in paragraph 28 to 30 of the CDM modalities and procedures are satisfied; Comments by local stakeholders have been invited, a summary of the comments received has been provided, and a report to the designated operational entity (DOE) on how due account was taken of any comments has been received; Project Participants have submitted to the DOE documentation on the analysis of the environmental impacts of the project activity, including transboundary impacts and, if those impacts are considered significant by the project participants or the host Party, have undertaken an environmental impact assessment in accordance with procedures as required by the host Party; The project activity is expected to result in a reduction in anthropogenic emissions by sources of greenhouse gases that are additional to any that would occur in the absence of the proposed project activity, in accordance with paragraphs 43 to 52 of the CDM modalities and procedures; The baseline and monitoring methodologies comply with requirements pertaining to methodologies previously approved by the Executive Board; Provisions for monitoring, verification and reporting are in accordance with decision 17/CP.7, the CDM modalities and procedures and relevant decisions of the COP/MOP; The project activity conforms to all other requirements for CDM project activities in decision 17/CP.7, the CDM modalities and procedures and relevant decisions by the COP/MOP and the Executive Board.
The following are requirements derived from paragraph 40 of the CDM modalities and procedures:
The DOE shall, prior to the submission of the validation report to the Executive Board, have received from the project participants written approval of voluntary participation from the designated national authority of each Party involved, including confirmation by the host Party that the project activity assists it in achieving sustainable development; In accordance with provisions on confidentiality contained in paragraph 27(h) of the CDM modalities and procedures, the DOE shall make publicly available the project design document; The DOE shall receive, within 30 days, comments on the validation requirements from Parties, stakeholders and UNFCCC accredited non-governmental organizations and make them publicly available; After the deadline for receipt of comments, the DOE shall make a determination as to whether, on the basis of the information provided and taking into account the comments received, the project activity should be validated; The DOE shall inform project participants of its determination on the validation of the project activity. Notification to the project participants will include confirmation of validation and the date of submission of the validation report to the Executive Board; The DOE shall submit to the Executive Board, if it determines the proposed project activity to be valid, a request for registration in the form of a validation report including of the project design document, the written approval of the host Party and an explanation of how it has taken due account of comments received.
There are only minor issues which should be addressed by the DOE/project participants prior to the registration of the project.
Additional information
1.The DOE shall further justify the suitability of the input values to the investment analysis in line with the paragraphs 113 (c) of VVM v1.2, in particular, the annual O & M cost of the proposed activity (each element of the annual O&M cost should be separately validated including the further explanation on what basis the reserve capacity fee has been determined). 2.The DOE should further substantiate the elimination of baseline alternative P7 (waste energy based captive electricity generation with lower efficiency than the project activity), in particular, how it has validated that either P7: i) has prohibitive barriers; or ii) is clearly economic unattractive as required by step 3 of identification of baseline scenarios of ACM0012 v3.2. 3.The DOE should further substantiate means of validation of fcap in line with ACM0012 v3.2 and paragraph 89-92 of VVM v1.2, in particular: (i) why fcap has not been calculated for each clinker production line (how it has validated the variation in waste heat availability in the both new and existing clinker production lines given that they have different capacities); (ii) how QOE,BL and QOE,y have been validated. In responding to this issue, the DOE should provide information (for both existing and new clinker production lines) on: (i) the quantity and energy content of the waste energy produced for the rated plant capacity/per unit of product produced; (ii) use of the waste heat to meet the internal energy demand of the clinker production lines; (iii) current practice in cement industry of using the waste heat to meet internal energy demand; (iv) total energy demand of the industrial facility; (v) specific energy consumption of the clinker production. 4.The PP shall measure the quantity of electricity supplied to the recipient plant by the project activity at the recipient plant and the generation plant for cross check as per the requirement of the methodology ACM0012 v3.2 ( pg no 40 and 41).
Date	11 Apr 11